Trunking: Cisco Call Manager Express PBX (UC520/540/560)

Configuration information for Cisco Call Manager Express UC520/540/560 PBX with sipgate trunking, including Voice Class setup.

Unfortunately, we don't have any documentation regarding the configuration of Cisco Call Manager Express UC520/540/560 PBXs. Instead, the following information should be useful for configuration:

• credentials - username XXXXXXt0 Password 7 xxxxxxxx realm sipconnect.sipgate.co.uk

• authentication - usernameXXXXXXt0 Password 7 xxxxxxxx realm sipconnect.sipgate.co.uk

• no remote-party-id

• retry invite 5

• retryregister 10

• timers connect 100

• registrar dns:sipconnect.sipgate.co.uk:5060 expires 600 (sec.)

• sip-server dns:sipconnect.sipgate.co.uk:5060

The Cisco PBX must send register requests to: sipconnect.sipgate.co.uk. IP addresses cannot be used in place of sipconnect.sipgate.co.uk. Cisco only supports numbers in the E.164 format (44123456789). The SIP ID lies outside of this range format.

To ensure the SIP ID is always included in the SIP request, this must be done with Voice Class

voice class sip-profiles 1 ➔ request ANY sip-header From modify "(<.*:)(.*@)" "<SIP-ID>@" ➔ request REGISTER sip-header To modify "(<.*:)(.*@)" "<SIP-ID>@"

This Voice Class must then also be activated under

voice service voip ➔ sip ➔ sip-profiles 1

With that the necessary header information is exchanged in real time and both SIP trunks and individual numbers should register. This requires firmware 15.2 (T2) and CME 8.1 or higher.